BASIC OF TRANSMISSION AND DISTRUBUTION SYSTEM
WHAT IS
MEAN BY CORONA?
- Corona
is a self-electrical discharge of atmosphere air
- If the operating voltage of the transmission line is more than dielectric strength of atmosphere air then the air molecules are ionized conducting path is created between the conductors, ozone gas is released if corona occurs.
- And also produce some violet glow
SKIN
EFFECT
Accumulation
of current on the surface of conductor is called skin effect due to skin effect
effective area of current flowing path is reduced which causes Rac>Rdc
SKIN EFFECT DEPENDS ON :-
- Frequency
- Conductivity
- Relative permeability
- Size of the conductor
- Skin depth
PROXIMITY
EFFECT
- It
occurs due to current flowing in mutual conductor reduces non uniform flux
linkages so that effect area of current flowing path is reduced which causes
Rac>Rdc.
- Proximity
effect depend on frequency, conductivity, permeability and distance between the
conductors.
- In case of power cable distance between the conductors is smaller so that proximity effect is higher in case of overhead distance is lager so that proximity effect is negligible.
FERRANTI
EFFECT
- In electrical engineering the Ferranti effect is an increase in voltage occurring at the receiving end of the transmission line above the voltage at the sending end.
- this occurs when the line is energized but there is a very light load or the load is disconnected.
- the capacitor line charging current produced a voltage drop across the line inductance that is in phase with the sending end voltage.
- assuming negligible line resistance.
- Therefore,
both line inductance and capacitance are responsible for this phenomenon.
LIGHTNING
ARRESTER
- It is the electrical equipment which protect the system like transmission, distribution and substation transient of voltage and current which produce due to the lightning stroke.
- Lighting arrester made of metal oxides like zine oxide, silicon carb
- It provides high resistance for normal voltage and low resistance for lightening surge.
- It
has impulse ratio of unity.
WHAT IS RING MAIN UNIT?
- In an electrical power distribution system, RMU is a switchgear unit, RMU used at the load connection points of ring-type distribution network.
- It includes in one unit two switches that can connect the load to either or both main conductors, and a circuit breaker that feed a distribution transformer.
- We can connect two or more supply to load with the help of RMU.
- it installs at load or section point.
- In RMU one supply is at standby mode and other supply the load.
There are two type of RMU: -
1. Indoor RMU
2. Outdoor RMU
3. way type RMU: -
a. 3way RMU: -
In this type of RMU, it contains
two isolator and one circuit breaker.
b. 4way RMU: -
In this type of RMU, it contains
two isolator and two circuit breakers.
working of RMU :-
in above fig.a we can see that 3way RMU .where supply is coming from two cable .but both connection are isolated . now we connect the one supply to transformer through isolator and circuit breaker and other connected to standby ,which is shown in fig.b
fig.b
if any fault occurs in cable no 2 then we disconnect it and connect supply to the load with cable no 1.in this way can maintain the re-ability system with help of RMU system.
fig.c